PANPACIFIC UNIVERSITYSchool Of EngineeringProblem set1. What is the value of surface tension of a small drop of water 0.3mm in diameter which is in contact with air if the pressure within the droplet is 561Pa?2. A Hg barometer at the base of Mt. Pek reads 600mm and at the same time another barometer at the top reads 450mm. What is the approximate height of Mt. Pek?3. A building in Panpacific University is 30m high above the street level. The required static pressure of water line at the top of the building is 20kg per square meter. What must be the pressure in kPa in themain water line located 4m below the street level?4. The viscosity of water at 20˚C is 1.008 centipoise. Compute for the following: a. Absolute viscosity in Pa-s b. Kinematic viscosity in m²/s and stokes5. Estimate the height to which water at 70˚F will rise in a tube of diameter 0.120in. Surface tension is 0.00497lb/ft. Express your answer in inches.6. In the figure shown what is the static pressure in kPa in the air chamber?2mOil 4m2m sg=0.803mH207. For the manometer shown, determine the difference in pressure between A and BOil, sg=0.85800mmB2000mmA Water8. Air is kept at a pressure of 200kPa absolute and at a temperature of 30˚C in a 500-liter container. What is the mass of the air?9. A liquid compressed in a container has a volume of 2liter at a pressure of 1MPa and a volume of 1 liter at a pressure of 2MPa. What is the bulk modulus of elasticity of the liquid?10. Determine the pressure difference between pipes A and B.WaterA 1.50mB1.0m0.50m 1.30mMercury11. A vertical rectangular gate 2m wide and 4m high is submerged in water with its top edge 2m below the water surface. Find the total pressure acting on one side of the gate and itslocation from the bottom.12. A vertical triangular surface of height 3m and horizontal base width of 1.5 m is submerged in a liquid with its vertex at the liquid surface. Determine the total force F acting on oneside and its location from the liquid surface.13. A 20m long Dam retains 8m of water. Find the total resultant force acting on the dam and the location of the center of pressure from the bottom.14. A dam is triangular in cross section with the upstream face vertical. Water is flushed withthe top. The dam is 8m high and 6m wide at the base. The coefficient of friction between thebase and foundation is 0.8. Determine the factors of safety against a) overturning ; b)sliding.15. The section of a concrete gravity dam shown in the figure. The depth of water at the upstream side is 6m. Neglect hydrostatic uplift and use unit weight of concrete equal to23.5 kN/m³. Coefficient of friction between the base of the dam and the foundation is 0.60.Determine the following; a) factor of safety against sliding; b) the factor of safety againstoverturning; c) the overturning moment acting against the dam in kN-m. for more information on Mechanics Of Fluid check on this:https://en.wikipedia.org/wiki/Fluid_mechanics

Don't use plagiarized sources. Get Your Custom Essay on

Mechanics Of Fluid

Just from $13/Page